Features:
Routes multiwire buses such as RS-232C
RS-232C and IEEE-488 interfaces
Poles switches in groups of 25
Solid state contacts
User friendly control programming
Bi-directional signal switching
Digital or analog signals
Digital/Analog Solid State Matrix
The 10046 is a multi-pole matrix switch which is programmable from a remote
control source. Standard interfaces are IEEE-488, RS-422 or RS-232C. Fully
expanded, the unit features a 12x24 25-wire matrix. Smaller configurations
are easily achieved by installing only the number of I/O and switching
matrix cards needed at the time. Additional cards can be added later if
expansion is necessary.
The 10046 can switch both digital and analog signals not exceeding ± 7
volts in amplitude. The 25 wires which switch in groups may also be controlled
in pairs for two or four wire analog switching. This is controlled by an
internal switch bank.
Each crosspoint in the matrix is addressable in a random fashion for maximum
flexibility. Special configurations or I/O connectors can easily be accommodated.
Consult the factory for your special requirement.
LINK TO: MODEL NUMBER ASSIGNEMENT
|
Applications:
RS-232C serial data lines
IEEE-488 parallel data lines
Modem to computer data lines
Twisted pair for Kelvin measurements in ATE
Audio intercom switching
Computer to peripheral switching
Configuration 12 Inputs x 24 outputs x 25-wire
Switching tech ISO-CMOS
On resistance 60 ohms, ±10 ohms
Maximum signal level ±7 volts max
Analog 600 ohm balanced pair performance
Freq. range DC to 5MHz (-3dB)
In/Out isolation >52dB @ 3.5MHz
>35dB @ 5MHz
Crosstalk isolation >45dB @ 5MHz
Risetime <15nS (into 75 ohms)
Control IEEE-488, RS-422, or RS-232C
AC power 115 VAC, ± 10%, 47-63Hz, 60W
Operating temp 0°C to +65°C
Storage temp -30°C to +85°C
Weight 50 lbs. (fully loaded)
Size 8.75"H x 19.00"W x 17.00"D
Mounting Chassis-Trak® C-230-D-120
Pivoting chassis slides w/5 point lock
|
